SEM 1015

	High Accuracy / 0.05%
	Small Size / High Packing Density
	DIN Rail Mount
	Current Converter

ISOLATES & CONVERTS
VOLTAGE SIGNAL to 4 to 20 ma
SEM1015

INTRODUCTION
The SEM1015 is a 4 to 20 ma isolator that can be configured to accept most of the common voltage ranges found in both commercial and industrial applications. The isolator range can be specified at time of order, but if required the user may re-range the transmitter to a new range. The isolator is housed inside a plastic enclosure, suitable for DIN Rail mounting. Screw terminals are provided for wire connections. The enclosure provides side entry access to coarse offset and span adjusters and a range select switch. The SEM1015 requires a single DC power supply (V1) to drive the output. The isolator is housed inside a plastic enclosure, suitable for DIN Rail mounting. Screw terminals are provided for wire connections.

V1 = Up to 30 VDC

Isolator Output Voltage Drop = 8 Volts Typical

Maximum Load =...	V1 - 8 V	....K ohms
	20 ma

Note: Non standard current inputs can be converted to voltages by use of an external resistor.

GENERAL SPECIFICATIONS @ 68ºF

.Input Range	.20mv to 100V
.Isolation	.1000 VAC RMS (Flash tested to 3 KV)
.Accuracy	.0.05% (including Hysteresis and Linearity)
.Stability	.P60 ppm/ºF
.Ambient	.32-158 ºF, 10-95% RH non-condensing
.Time Constant	.0.1 sec (to 63% of final value)
.Adjustments	.Front entry Zero & Span Potentiometers

APPROVALS

.EMC	.TESTED TO:
.IEC 801-2	.Susceptibility to electrostatic discharge
.IEC 801-3	.Radiated Susceptibility
.IEC 801-4	.Susceptibility to conducted interference
.EN 55022	.Radiation emissions

MECHANICAL

.Mounting	.DIN Rail
.Connections	.Captive terminal screws
.Cable size	.12 AWG solid / 14 AWG Stranded
.Flammability	.UL94-V0, VDE 0304 Part 3 Level IIIA

DOWNLOADS
SEM1015 Instruction Manual

SEM1015 Literature

ORDER CODE

SEM1015 Isolator and Voltage to Current Converter