88 Pro

	Lowest cost process meter
	Broad scaling capability
	4-20mA, 10-50mA, or 1-5mA I/P
	Very competitive pricing
	Fast deliveries, normally in stock
	Normal or inverted scaling
	Simple and attractive facial design
	Extra x10 and x100 digits
	High quality plug-in terminals
	Units-of-measure label fitted
	Low loop drop 2.5V max

Connection Example

The 88-Pro may be connected to a wide range of signal loops, without additional auxiliary or loop excitation power supplies, because the meter is self powered and drops only 2.5V in the loop.

The simple example shown could be used for measuring the contents of a straight sided liquid storage tank. The transmitter would be sited near the bottom of the tank, and as liquid level rises, so the pressure at the base would rise. The meter's broad scaling capabilities allow it to be adjusted to read in true volume.


·	The 88-Pro displays a wide range of process variables such as temperature, pressure, flow, weight, pH, humidity, etc. It accepts most process signals, such as 4-20mA and 1-5mA, and gives superb value for money.
·	The loop voltage drop is only 2.5V
·	The simple bezel will compliment your panel design. The lens protects all legends and markings, so repeated wipe-downs won't damage the lettering or display clarity. High contrast LCDs make these meters suitable for use in bright environments.
·	You can extend the maximum reading up to 19990 or 199900 with fixed zeros, selected by jumper switches. This is useful when the cost of a 4 1/2 or 5 1/2 digit meter may be too high.
·	There's also an INVERT facility, so an increasing input signal gives a reducing display, for example 4-20mA=100.0 to 0.0.
·	The case depth is less than that of our other process meters, saving you valuable space in the panel. << BACK TO ELECTRONICS

The design of the connectors means that no extra depth is required for cable loops. The cable exits the bottom surface of the connector, not the rear.

Panel Cutout
45mm high, 92mm wide
Tolerances +1mm, -0mm

Bezel Size=48x96mm